Instructions for Connecting your Reverse Osmosis Replacement Filters

Replacing Your Reverse Osmosis Filter Cartridges

REVERSE OSMOSIS REPLACEMENT INSTRUCTIONS

Product Code: FRO-DM-UKWF

Step 2  POST FILTER CHANGING

(These are the two filters on top of the unit ie Filter 1 and Filter 2) in image 1 above

Remove the pipe / tubing from inlet/outlets by depressing small collect ring IN whilst pulling the pipe OUT. (If relevant) first remove the blue collect lock from the push fit connectors on inlet/outlet.

Install new post filters – exchanging like for like - ensuring correct direction of flow. (Note the way the ends “D” fit compared with the membrane at “D1”)

Filter 1 inlet comes from Filter 2. The outlet goes to your sink top Tap / faucet

Filter 2 inlet connects to the T piece and outlet connects to Filter 1

Step 3 PRE FILTER CHANGING

(These are Filters 3 and 4 that sit in the white cylinders underneath the unit. They look identical).

Place a drip tray beneath the system to catch any water.

Unscrew the housings that sit under the main unit by turning to the left (Use the special spanner if available - or you could

use an oil-filter type spanner. Do NOT use the in/out ports as leverage or you might weaken and break them).

Remove the old filters and discard. Place the new filters into the housing and tighten. DO NOT OVERTIGHTEN.

Step 4 Restart the system.  To do this reverse Step 1 above. Turn back on the water supply to the unit.

Turn the tap on the TOP of the storage tank to the open position. Check for any small leaks and empty the first two tank fulls of water to remove any carbon fines / carbon dust.

Any Problems? Please Telephone 0800 009 6611 Please note your feedback and any suggestions as to how we can improve our service are always appreciated.

Water Filter instructions / Guides for fitting and installing